Nissan GT-R jack pad tool

Nissan GT-R Jack Pad Tool

When inserted into the pockets of the GT-R jack points the R35 jack pad tool protects the side skirts and undercarriage from being damaged by a floor jack. When used in sets of four, the R35JPT tools obviate the need for the special lifts used by authorized Nissan GT-R dealers. The GT-R tool uses Silicone plugs to hold the jack pad tool in place while a floor jack or the arms of a four-arm lift are maneuvered into place under the jack point. The base on the aluminum tools for the R35 chassis is 63mm in diameter and requires a floor jack with a 3" diameter saddle.

Multi-Vehicle Jack Pad Tool (tall)

SKU MV52-30-28
$27.45
Out of stock
1
Product Details

The aluminum block on the MV52-30-28 jack pad tool measures 52mm long by 30mm wide by 28mm high. These dimensions allow this tool to be used with cars that have an integrated vehicle jack pocket in the factory jack points. This includes most modern BMWs, MINIs, non-AMG Mercedes, and the Nissan GT-R. For floor jacks with removable saddles, the optional 30mm or 25mm diameter pin allows use of the tool without a floor jack saddle. A low profile floor jack is normally required to use this tool. Unlike our other chassis specific jack pad tools below, this mutli-vehicle tool does not hang from the factory jack points. The “universal” dimensions of the block preclude this feature from being incorporated into the MV52-30-28 jack pad tool model.


This tool must be used with a floor jack which has at least a 3" diameter saddle.

Save this product for later