W203 jack pad tool w/floor jack

Jack Pad Tools for Mercedes-Benz

Most Mercedes-Benz vehicles introduced after the 2000 model year incorporate a combination jack point which can be used with either the vehicle jack or the dealer service department lift. The Reverse Logic jack pad tools for Mercedes-Benz with spring loaded pins leverage a small notch in either end of the jack point pocket. The pins in the ends of the jack pad tool block are positioned to snap into these notches and temporarily suspend the tool while a floor jack can be positioned below the jack point. With the jack pad tool in place the car can be safely lifted with a floor jack without damaging the side skirts or undercarriage. Our line of aluminum tools for Mercedes-Benz chassis require a floor jack with a saddle that is a minimum of 3" in diameter to accommodated the 63mm diameter base.

Read More

Jack Stand Blocks for Torin T43004 (Pair)

SKU JB52-30-28
$34.95
Out of stock
1
Product Details

Customers who already own a set of Torin (or equivalent) aluminum jack stands with a flat top saddle can use these 52mm by 30mm by 28mm aluminum blocks to adapt the jack stands for use with BMW, MB, or Nissan GT-R jack points. The blocks include 40mm long headless bolts. A 10.1mm diameter hole must be drilled through the center of the jack stand saddle in order to use the blocks. Sold in pairs.

ALWAYS USE JACK STANDS IN PAIRS. DO NOT SUPPORT YOUR CAR WITH ONE, THREE, OR FOUR JACK STANDS. USE WHEEL CHOCKS IN FRONT AND BEHIND THE WHEELS ON THE GROUND.

Save this product for later