W203 jack pad tool w/floor jack

Jack Pad Tools for Mercedes-Benz

Most Mercedes-Benz vehicles introduced after the 2000 model year incorporate a combination jack point which can be used with either the vehicle jack or the dealer service department lift. The Reverse Logic jack pad tools for Mercedes-Benz with spring loaded pins leverage a small notch in either end of the jack point pocket. The pins in the ends of the jack pad tool block are positioned to snap into these notches and temporarily suspend the tool while a floor jack can be positioned below the jack point. With the jack pad tool in place the car can be safely lifted with a floor jack without damaging the side skirts or undercarriage. Our line of aluminum tools for Mercedes-Benz chassis require a floor jack with a saddle that is a minimum of 3" in diameter to accommodated the 63mm diameter base.

Read More

Jack Pad Tool for MB R230 W220 W210 W140

Out of stock
Product Details

The Reverse Logic R230JPT jack pad tool extends the height of the existing vehicle jack point providing more clearance for the rim of a floor jack saddle or the arms of a four-arm lift. The jack pad tools are not intended to be permanently installed on the car. The knurl and groove around the circumference of the tool make it easy to twist the tool into place and to remove it when the maintenance is completed. The tool is machined from Delrin and uses a Silicone O-Ring to "grab" onto the vehicle jack point. No modifications to the vehicle jack points are required to use the R230JPT tool. Fits R230, W220, W210, and W140 vehicle jack points.

This tool must be used with a floor jack which has at least a 2.75" diameter saddle.

Save this product for later