Tesla Model Y jack pad
Jack pad tool in Tesla Model Y chassis.

Chassis Specific Jack Pads

Do-it-yourselfers who are passionate about their cars will appreciate the innovative and practical solution that Reverse Logic jack pad tools offer. Most of our chassis specific tools hang from the jack points of your car and prevent damage to the side skirts and undercarriage of your car while using a floor jack.

Our tools with spring loaded bullet latches fit many Mercedes-Benz chassis introduced after the 2000 model year. Late model BMW, MINI Cooper, Mercedes-Benz chassis and the Nissan GT-R will accept our jack pad tools with silicone plugs which retain the tools in place.

Our jack pad tool for Corvette C5/C6/C7/C8 chassis allows the tool to be used in one of two ways. It can be suspended from the jack point or secured in place for extended maintenance periods.

The jack pad tool for Porsche uses a custom T-nut sized to fit the oval hole in the jack point of Porsche 964, 991, 996, 986, 997, 987, and 981 chassis.

Tesla Model S•X and Model 3•Y chassis specific jack pad tools are the latest addition to the Reverse Logic jack pad product line. More details about the tools are available in the drop down menu selections under Jack Pads.

E88JPT Jack Pad Tool

Out of stock
Product Details

The E88JPT model fits all BMW chassis with a slightly shorter pocket in the vehicle jack point. This includes the 1-Series E88 Convertible, the 3-Series E93 Convertible, the F20/21 1-Series, F22/23 2-Series, the F30/31/34/35/80 3-Series, the F32/33/36/82/83 4-Series, F12 6-Series, and F55/56 MINI. Consult the application chart in the photo gallery to determine which jack pad tool fits your vehicle. The base for the E88 tool is 68mm in diameter by 11mm thick. The E88JPT uses Silicone plugs to provide a friction fit in the jack point pockets. When the tools are suspended from the jack points it is very easy to align a floor jack with the jack point. The Silicone plugs are pressed into holes in the block and expanded with a small plastic screw.

The block on the R50JPT and E88JPT as the same dimensions. However, the Silicone plugs are recessed deeper below the surface of the block which effectively shortens the length of the E88 tool as compared to the R50 tool.

This tool must be used with a floor jack which has a saddle at least 3" in diameter.

Save this product for later