Audi jack pad tool with R8

Jack Pad Tools for Audi/Porsche/VW

The Reverse Logic jack pad tool for Audi chassis is compatible with the R8, TT Mk2, and other RS, and S chassis which use a jack point with a half circle shaped pocket. Typical chassis jack points for these Audi models are shown below. The jack point in the R8 chassis is recessed as shown in the photo. This tool is not intended to be used with Audi chassis with pinch weld jack points.

An anodized aluminum bar-shaped "block" is bolted to the base with an M10x1.5 bolt. The shape of the block allows the car to be lifted without binding against the side of the block. No modifications to the jack pad receptacles on your car are required to use this jack pad tool.

Read More

Jack Pad Tool for Porsche

In stock
Product Details

The aluminum base on the P-JPT jack pad tool measures 63mm in diameter. The T-nut has a diamond shaped shaft that limits the tool from being turned more than 90˚ once it is inserted into the oval hole at the chassis jack point. The washer is held in place by the T-nut and protects the chassis from being scratched. This tool must be used with a floor jack which has at least a 3" diameter saddle.

Save this product for later